Negative Adjustable Power Supply

This is a negative adjustable power supply. The power supply is regulated based on LM337T regulator IC. The LM337T is a regulator for negative voltage. This power supply output current is 1.5A max.

Schematic diagram:

Power Supply Input:

Component part list:
R1 = 330
R2 = 1K
VR1 = 10K 10-turn trimpot
C1 = 2200uF/50V
C2,4 = 100nF ceramic
C3,4 = 10uF/63V
D1-6 = 1N5403
REG IC = LM337T
Heatsink

This circuit is available in kit module at electronickits.com, you may buy the this power supply kit there. Here the manual of the kits which containing the schematic diagram, part list and the explanation of the power supply circuit.

Comments

Anonymous said…

I really impress on your article such you have to providing very nice information about LM337T regulator IC for negative adjustable power supply so thanks for sharing.
power supply

September 24, 2010 at 9:47 PM

LM317T Voltage Regulator Circuit with Pass Transistor

This is the schematic diagram of voltage regulator circuit with pass transostor. The regulator is based regulator IC of LM317T. The LM317T output current can be raised by utilizing an additional power transistor (on circuit, it is 2N2955) to share a portion of the total current. The amount of current sharing is established with a resistor placed in series with the LM317 input and a resistor placed in series with the emitter of the pass transistor. In the above scheme design , the pass transistor will start conducting when the LM317 current reaches about 1 ampere, due to the voltage drop across the 0.7 ohm resistor. Current limiting happens at about 2 amperes for the LM317 which will drop about 1.4 volts across the 0.7 ohm resistor and make a 700 millivolt drop across the 0.3 ohm emitter resistor. Thus the total current is limited to about 2+ (.7/.3) = 4.3 amperes.

Sealed Lead Acid (SLA) 12V Battery Charger with Current Limiting

This is the circuit design of Smart Sealed Lead Acid (SLA) 12V Battery Charger featuretwith Current Limiting. The charger uses a two step process for charging SLA batteries – a current limited ‘fast’ mode followed by a constant voltage ‘float’ mode. Maximum charging current is 1A. An onboard LED indicates when the charger is in ‘fast’ mode. When the LED goes out the battery is charged and the charger has switched to ‘float’ mode.

6V to 12V DC Voltage Doubler

Here is the 6V to 12V DC voltage doubler circuit design, it also called DC voltage miltiplier or DC to DC converter. This dc voltage doubler circuit will need about 2A from the 6V input supply to produce the full 800mA at 12V for the power output. This circuit is very useful to generate higher voltage from a low power source, but this circuit will deliver low output current. So it should only be used for low current driven applications. Also, the output voltage may be unstable, so a voltage regulator (IC78XX) of proper rating can be used regulation and smooth output. But voltage regulator IC itself consume some current, and reduce the deliverable current.

Power Supply Adapter

Search This Blog