Variable Lab Power Supply 0-24V / 4A

Variable lab power supply 0-24V / 4A, it is a laboratory power supply with output voltage continuously adjustable from 0 V to 24 V DC, remote voltage sense capability (Sense internal/external). It has output current limit which is continuously adjustable from 0.04 A to 4 A and output current which can be limited continuously or output shut down (Limit/cut).

Remote sensing means that there are actually two extra wires which sense the delivered voltage at the load and compensate for any voltage drop along the cables which carry the delivered electric current. This improves voltage regulation at the load significantly but needs two extra wires for the sensing. A switch will allow internal sensing at the output terminals for easier operation when remote sensing isn't necessary.

Read the detailed explanation about Variable Lab Power Supply 0-24V / 4A

Comments

LM317T Voltage Regulator Circuit with Pass Transistor

This is the schematic diagram of voltage regulator circuit with pass transostor. The regulator is based regulator IC of LM317T. The LM317T output current can be raised by utilizing an additional power transistor (on circuit, it is 2N2955) to share a portion of the total current. The amount of current sharing is established with a resistor placed in series with the LM317 input and a resistor placed in series with the emitter of the pass transistor. In the above scheme design , the pass transistor will start conducting when the LM317 current reaches about 1 ampere, due to the voltage drop across the 0.7 ohm resistor. Current limiting happens at about 2 amperes for the LM317 which will drop about 1.4 volts across the 0.7 ohm resistor and make a 700 millivolt drop across the 0.3 ohm emitter resistor. Thus the total current is limited to about 2+ (.7/.3) = 4.3 amperes.

Sealed Lead Acid (SLA) 12V Battery Charger with Current Limiting

This is the circuit design of Smart Sealed Lead Acid (SLA) 12V Battery Charger featuretwith Current Limiting. The charger uses a two step process for charging SLA batteries – a current limited ‘fast’ mode followed by a constant voltage ‘float’ mode. Maximum charging current is 1A. An onboard LED indicates when the charger is in ‘fast’ mode. When the LED goes out the battery is charged and the charger has switched to ‘float’ mode.

5V to Isolated 5V Converter Circuit

This is the circuit diagram of 5V to Isolated 5V Converter, rated at 20mA electric current. In this converter circuit, a negative output voltage dc to dc converter generates a -5V output at pin A. In order to generate -5V at point A. the primary of the transformer must fly back to a diode drop more negative than -5V. If the transformer has a tightly coupled I : 1 turns ratio. there will be a 5 V plus a diode drop across the secondary. The IN5817 rectifies this secondary voltage to generate an isolated 5V output. The isolated output is not fully regulated since only the -5V at point A is sensed by the MAX635.

Power Supply Adapter

Search This Blog